Ford BA Falcon Barra Turbo engine stand alone body wiring loom, suits a manual gearbox or BTR 4 speed automatic transmission. This loom connects to the existing BA engine loom and ECU and will allow you to start and run the engine and drive when the ECU security is removed. This loom fits the engine and is not specific to any vehicle, boat, water pump or application you have. It will allow you to start the engine 5 wires you need to connect 1.Earth 2. 12Volts+ to the fuse box 3. Ignition On/Off 4. Start and 5 Fuel Pump. All other plugs and connectors are wired and ready to plug and play. There are plugs for the accelerator pedal, T bar shifter, OBD2 diagnostic, radiator fans, power steering pressure switch, inlet runner control, purge valve, oxy sensor, boost sensor, and wastegate actuator. Manual vehicles do not need a speed signal. The auto transmission needs the speedo sensor drive (non ABS type) or you can have it fitted by changing the extension housing and fitting the drive gear(EF-AU).This loom is made from used OEM looms and a new fuse/relay box, all new connections have been soldered. All wires and plugs are labelled for easy identification This loom has been run and tested on an engine. This loom has provision for air conditioner, neutral safety switch and reverse lights.